Switch to CMake - Taranis bootloader added. Tests done.

radio/src/targets/taranis/lcd_driver.cpp

@@ -27,16 +27,6 @@
 bool lcdInitFinished = false;
 void lcdInitFinish();
 
-/*
-  delaysInit() must be called before the first call to this function!
-*/
-static void Delay(uint32_t ms)
-{
-  while(ms--) {
-    delay_01us(10000);
-  }
-}
-
 #if defined(REVPLUS)
 
 // New hardware SPI driver for LCD
@@ -71,7 +61,7 @@ void initLcdSpi()
 static void LCD_Init()
 {
   WriteCommand(0x2F);   //Internal pump control
-  Delay(20);
+  delay(20);
   WriteCommand(0x24);   //Temperature compensation
   WriteCommand(0xE9);   //set bias=1/10
   WriteCommand(0x81);   //Set Vop
@@ -106,7 +96,7 @@ static void LCD_Init()
 static void LCD_Init()
 {	
   AspiCmd(0x2B);   //Panel loading set ,Internal VLCD.
-  Delay(20);
+  delay(20);
   AspiCmd(0x25);   //Temperature compensation curve definition: 0x25 = -0.05%/oC
   AspiCmd(0xEA);	//set bias=1/10 :Command table NO.27
   AspiCmd(0x81);	//Set Vop
@@ -349,7 +339,7 @@ void lcdOff()
   to re-init LCD without any delay
   */
   AspiCmd(0xAE);    //LCD sleep
-  Delay(3);	        //wait for caps to drain
+  delay(3);	        //wait for caps to drain
 }
 
 /*
@@ -357,7 +347,7 @@ void lcdOff()
   soon as possible after the reset because LCD takes a lot of
   time to properly power-on.
 
-  Make sure that Delay() is functional before calling this function!
+  Make sure that delay() is functional before calling this function!
 */
 void lcdInit()
 {
@@ -367,7 +357,7 @@ void lcdInit()
 
   //reset LCD module
   LCD_RST_LOW();
-  Delay(1);       // only 3 us needed according to data-sheet, we use 1 ms
+  delay(1);       // only 3 us needed according to data-sheet, we use 1 ms
   LCD_RST_HIGH();
 }
 
@@ -404,13 +394,13 @@ void lcdInitFinish()
 #if !defined(BOOT)
     while(g_tmr10ms < (RESET_WAIT_DELAY_MS/10)) {};    //wait measured from the power-on
 #else
-    Delay(RESET_WAIT_DELAY_MS);
+    delay(RESET_WAIT_DELAY_MS);
 #endif
   }
   
   LCD_Init();
   AspiCmd(0xAF);	//dc2=1, IC into exit SLEEP MODE, dc3=1 gray=ON, dc4=1 Green Enhanc mode disabled
-  Delay(20);      //needed for internal DC-DC converter startup
+  delay(20);      //needed for internal DC-DC converter startup
 }
 
 void lcdSetRefVolt(uint8_t val)