Files
openipc-builder/devices/gk7205v200_otg_generic/general/overlay/etc/init.d/S72usbmode
T
OpenIPC AI teamandGitHub f86ea4f4a6 gk7205v200_otg: settle the USB role before xHCI probes (#147)
The OTG profile could not see USB devices in host mode. On a board with a
UVC webcam on the USB tail, `lsusb` showed only the two root hubs, while the
same board running a plain lite image enumerated the webcam normally.

The controller was in the host role and the host controller was running --
mode file "host", xhci-hcd bound, USBCMD 0x5, PORTSC1 port-power set -- and
the port still never reported a connect (PORTSC1 0x00000280, CCS clear).

dr_mode = "otg" makes dwc3_core_init() program GCTL.PRTCAPDIR = OTG(3), and
dwc3_core_init_mode() registers xhci-hcd on top of that. This 4.9 dwc3 has no
working OTG role-detection block, so xHCI probes, resets the controller and
brings up its root hubs while the core is in a role it cannot drive. The port
is then dead for the life of that probe.

S72usbmode's `usb-mode host` did not repair it and could not: writing the
debugfs mode file reaches dwc3_set_mode(), which flips GCTL.PRTCAPDIR and
nothing else, leaving the already-probed xHCI with the port state machine it
built in OTG. It also skipped the bind, because xhci-hcd was already bound.

Fix it where the ordering is: patch dwc3_core_init() to program
PRTCAPDIR = HOST for the OTG case, so xHCI probes into a role the core can
drive. dwc3_gadget_init() only registers a UDC and does not care, and
`usb-mode device` re-aims the controller itself when it takes the port.

usb-mode's host path also learns to re-probe an xHCI that was bound in some
other role, which is what makes a newer rootfs recover on an older kernel.
2026-09-06 09:57:08 +03:00

35 lines
967 B
Bash
Executable File

#!/bin/sh
#
# Force a concrete USB role at boot.
#
# The device tree sets dr_mode = "otg" so that dwc3 registers both an xHCI host
# and a UDC, which is what makes runtime role switching possible. The role
# itself is settled in the kernel: all-patches 0018 programs
# GCTL.PRTCAPDIR = HOST before the xHCI host is registered, because a host that
# probes while the core is still in OTG(3) comes up unable to drive the port --
# it runs, powers the port, and never reports a connect. So the board boots as
# a host, and this script exists to apply a persisted "device" choice on top.
#
# Runs after S70vendor so the vendor modules are up first.
case "$1" in
start)
mode=host
[ -r /etc/usbmode ] && read -r mode < /etc/usbmode
case "$mode" in
host|device) ;;
*) mode=host ;;
esac
echo "Setting USB role to $mode..."
/usr/bin/usb-mode "$mode" || echo "usb-mode $mode failed"
;;
stop)
;;
*)
echo "Usage: $0 {start|stop}"
exit 1
;;
esac