Updates to allow sticks to be reversed at compile time.

e.g.
make PCB=SKY9X FRSKY=YES HAPTIC=YES AUDIO=YES STICK_AIL_REV=YES STICK_THR_REV=YES STICK_RUD_REV=YES

src/Makefile

@@ -89,6 +89,11 @@ NAVIGATION = NO
 # Values = YES, NO 
 AUTOSWITCH = NO
 
+# Swap Stick Inputs for AIL,ELE,RUD,THR
+# Used in some scenarios where stick/pot entries
+# cannot be changed by soldering the pots.
+
+
 # Sources automatic selection
 # Values = YES, NO 
 AUTOSOURCE = NO
@@ -741,6 +746,22 @@ ifeq ($(AUTOSOURCE), YES)
   CPPDEFS += -DAUTOSOURCE
 endif
 
+ifeq ($(STICK_AIL_REV), YES)
+  CPPDEFS += -DSTICK_AIL_REV
+endif
+
+ifeq ($(STICK_ELE_REV), YES)
+  CPPDEFS += -DSTICK_ELE_REV
+endif
+
+ifeq ($(STICK_RUD_REV), YES)
+  CPPDEFS += -DSTICK_RUD_REV
+endif
+
+ifeq ($(STICK_THR_REV), YES)
+  CPPDEFS += -DSTICK_THR_REV
+endif
+
 ifeq ($(DBLKEYS), YES)
   ifeq ($(PCB), $(filter $(PCB), 9XR 9XR128 9XR2561))
     $(warning Sorry, DBLKEYS doesnt work on 9XR)

src/opentx.cpp

@@ -2265,8 +2265,36 @@ BeepANACenter evalSticks(uint8_t mode)
       v = -v;
 #endif
 
+
+#if defined(STICK_THR_REV)   
+    v = -v;
+    if (g_model.throttleReversed && ch==THR_STICK)
+      v = +v;
+#else
+    //normal stick operation but reveresed in model config
     if (g_model.throttleReversed && ch==THR_STICK)
       v = -v;
+#endif
+      
+#if defined(STICK_AIL_REV)   
+    if (ch==AIL_STICK)
+      v = -v;
+#endif
+      
+#if defined(STICK_ELE_REV)   
+    if (ch==ELE_STICK)
+      v = -v;
+#endif
+
+#if defined(STICK_RUD_REV)   
+    if (ch==RUD_STICK)
+      v = -v;
+#endif
+
+  
+      
+ /* end rob hack */       
+      
 
 #if defined(EXTRA_3POS)
     if (i == POT1+EXTRA_3POS-1) {